Version mobile

Jason Postlaunch Satellite Characteristics for POD activities

Satellite reference system

The reference axes for Jason are similar in orientation to those of TOPEX/Poseidon. The X axis is along the satellite's main direction, pointing from the attachment ring towards the radiometer antenna. The Y axis is transverse, along the solar panels. The Z axis is radial, pointing towards the Earth.

The reference point is at the center of the attachment ring.

Mass and center of mass

The fuel tanks on Jason have been designed and aligned so that the center of mass of the spacecraft as a whole only moves along the X direction during the satellite's life in orbit. By construction this is the X axis, so that the Y and Z coordinates of the center of mass in the spacecraft frame are always zero.

The table below gives the spacecraft mass first after deployment in orbit, then once 8 kg of hydrazine have been used. The expected cost of the station acquisition is around 5 to 6 kg. Both the spacecraft mass and center of mass location will be updated once in orbit, and throughout the life of the mission.

  Mass (kg) X center of mass (mm)
after deployment in orbit 489.1 935
minus 8 kg of hydrazine 481.1 942

This mass and center of mass are for the whole spacecraft, including the solar panels. For information, the solar panels' mass is 42.4 kg, and their center of mass is located on the X axis at 855 mm.

Attitude control

The attitude control law for Jason is identical to that of Topex/Poseidon. Its yaw motion is designed to keep the proper orientation of the solar panel rotation axis. Its pitch motion keeps the altimeter antenna pointed perpendicular to the reference ellipsoid.
When the angle of the Sun over the orbit plane is smaller than 15 degrees, the yaw rotations are stopped and the satellite is placed in fixed yaw. When the Sun crosses the orbit plane, the satellite reverses itself (flip).
Contrary to Topex/Poseidon, the transition between fixed and sinusoidal yaw modes for Jason should occur at well defined times. For each day of the cycle, there is an identified orbit when the transition can occur, close to the sub Solar point in order to minimize rotations. Thus it should be possible to predict when these tansitions will occur. In the short term, we will provide an Satellite Attitude Events File similar to the one for Topex/Poseidon. There might be a possibility to also provide quaternions in the future.

Macro-models

Macro-models for Jason have been derived from a detailed satellite description file provided by the manufacturer. These data were used to compute a micro-model for the spacecraft central body. Accelerations due to solar radiation were computed for all possible incoming light directions using this model. A simplified 6-face box model was then optimally adjusted to reproduce these accelerations as accurately as possible. As the box model was adjusted to the whole set of incoming directions it can be used for direct solar radiation pressure computation as well as for albedo computation.

The product of the surface by the optical coefficient is the only factor that matters in the computation of the accelerations. We used this degree of freedom to set the areas of the box model to the actual projected surfaces of the satellite, instead of applying the usual normalization which sets the sum of coefficients to 1. The advantage of this approach is that the same physical model can be used for drag and radiation forces. If your software requires normalized coefficients, just resize the surfaces!

Care was taken to include all effects in the model. In particular, the visible model takes into account the fact that the energy absorbed by the thermal blanket is completely reradiated at infrared wavelengths (it does not contribute to heating up the spacecraft). The visible properties of the blanket were modified to account for this effect. Additional details will be provided in a technical note.

For the solar arrays, SA+ corresponds to the face turned toward the Sun.

Jason visible
surfaces
X+ X- Y+ Y- Z+ Z- SA+ SA-
area
1.65 1.65 3.0 3.0 3.1 3.1 9.8 9.8
specular ref.
0.436 0.434 0.357 0.321 0.240 0.318 0.344 0.004
diffuse ref.
0.209 0.215 0.375 0.400 0.402 0.370 0.006 0.298
absorbed ref.
-0.001 0.005 0.271 0.308 0.330 0.267 0.647 0.697
Jason infra-red
surfaces
X+ X- Y+ Y- Z+ Z- SA+ SA-
area
1.65 1.65 3.0 3.0 3.1 3.1 9.8 9.8
specular ref.
0.425 0.408 0.334 0.274 0.236 0.298 0.097 0.035
diffuse ref.
0.178 0.186 0.342 0.369 0.382 0.336 0.098 0.035
absorbed ref.
-0.026 -0.012 0.249 0.297 0.309 0.240 0.803 0.931

In order to take in account the thermal emissivity in routine operation, resulting from the energy dissipated by the various instruments and radiated through the radiators, one has to add a constant bias force fixed with respect to the satellite's frame

emissivity  radiated power (W) force (µN)
Xs 40 -0.09
Ys 80 -0.18
Zs 0-8 0.0

Instruments phase centers

The phase centers of the various instruments of Jason are given below in the satellite frame

  X (mm) Y (mm) Z (mm)
Altimeter 1616.0 0.0 477.5
Doris 2GHz 1171.0 - 598.0 1027.0
Doris 400 MHz 1171.0 - 598.0 859.0
LRA (optical center) 1171.0 598.0 682.8
GPS 1 - L1 2408.0 219.7 -537.2
GPS 1 - L2 2420.1 220.7 -558.3
GPS 2 - L1 2408.0 -219.7 -537.1
GPS 2 - L2 2420.2 -220.8 -558.5

Doris

Note that for Doris, the export data is referenced to the 2 GHz frequency (the position of the 400 MHz phase center is not required). The two Doris receivers are connected to the same antenna.

GPS

For the Turbo-Rogue GPS Space Receiver, the two receivers are connected to independant antennas. The receiver that will be turned-on after launch is the 2. The GPS antennas are tilted with respect to the satellite's axes. The spacecraft relative phase locations are thus obtained by applying a rotation to the phase center positions measured relative to the antenna.

The following tables give the reference points of the GPS antennas with respect to the spacecraft, the rotation matrices going from the satellite's frame to the antenna frame, and the location of the phase centers in antenna frame.

reference points X (mm) Y (mm) Z (mm)
GPS 1 2370.5 216.4 -472.1
GPS 2 2370.5 -216.4 -472.1

rotation matrix from satellite frame to antenna frame for GPS 1

0.867 -0.025 0.497
0.000 -0.999 -0.050
0.498 0.044 -0.866

rotation matrix from satellite frame to antenna frame for GPS 2

0.867 0.025 0.497
0.000 -0.999 0.050
0.498 -0.044 -0.866

antenna phase center in antenna frame (along the antenna axis)

  Z (mm)
GPS 1 L1 75.2
GPS 1 L2 99.5
GPS 2 L1 75.1
GPS 2 L2 99.8

LRA

Here is the description of the LRA that we have received. We propose to use a constant correction of 4.9 cm to perform the first POD analyses.

 

If you experience any problem processing the Jason data or understanding the spacecraft description, please contact:

CNES Precise Orbit Determination Group 
18 avenue E. Belin 
31401 TOULOUSE Cedex 4 
France

EnglishFrançais
Flux RssContactPartenairesFAQLexiqueMentions légalesPolitique de protection des données personnellesMobile
Vous devez activer les cookies dans votre navigateur afin que vos préférences soient enregistrées.
Vous utilisez une ancienne version d'Internet Explorer, mettez le à jour pour profiter pleinement des fonctionnalités d'Aviso+

Personnaliser la page d'accueil

Tout voir
Affichage reduit
Grand public
Utilisateur

Sélectionner un widget

Découvrir AVISO+

Accueil personnalisable, outils de lecture, guide de recherche produits, etc. Découvrez pas à pas les nouvelles fonctionnalités du site AVISO+.

Page d'accueil personnalisable

La nouvelle page d'accueil se compose de blocs appelés "widgets".

Réorganisez les blocs avec un "Click & Drop".

Masquez un widget avec la croix en haut à droite. Réinitialisez ou ajoutez un widget avec l'icone "Clé à molette". Les profils "Utilisateur" et "Grand public" vous proposent une organisation prédéfinie.

Toutes les modifications sont automatiquement enregistrées en cookies sur votre poste. Vous créez ainsi votre propre AVISO+.

Outils de lecture

Améliorez votre confort de lecture en personnalisant la couleur de fond des pages (noir/blanc) et/ou en modifiant la taille de la police.

Menu navigation et fil d'Ariane

Afin de faciliter votre navigation au sein d'AVISO+, vous pouvez à tout moment naviguer en utilisant les rubriques et sous-menus interactifs ou le menu navigation sur la gauche de votre écran (ouvert par défaut). Pour plus de lisibilité du contenu des pages, le menu de navigation peut se replier sur le côté et réapparaître grâce au petit onglet de va-et-vient. A tout moment, vous pouvez retrouver votre position dans le site grâce au menu navigation ou grâce au fil d'Ariane, situé en haut des pages.

Guide de recherche de produits

Le premier sous-menu de la rubrique "Données" vous amène à un nouveau formulaire de recherche vous permettant de trouver plus rapidement le produit qui vous convient. Une liste de résultats s'actualise en fonction de vos critères de sélection.

Nouvelle galerie AVISO+

Le premier sous-menu de la rubrique "Multimédia" vous conduit à la galerie AVISO+ regroupant une sélection d'images et de vidéos en lien avec l'altimétrie et ses applications. Bonne visite!